Manually setting TCP/IP Addresses | Installation | |
At the WorkCentre PE120i, perform these steps: | ||
| ||
HINT: Xerox CentreWare Internet Services can also be used to configure the | Network | |
WorkCentre PE120i, refer to the Internet Services chapter for instructions. | ||
| ||
When manually making the TCP/IP settings, you will need to know the following information: | Basic | |
¾ The IP address. | ||
| ||
¾ The subnet mask, if required. |
| |
¾ The Gateway address, if required |
|
1
2
3
¾Press [Menu] until you see Network Setup on the top line of the display.
¾Press 
or 
until Configure Network is displayed and press [Enter].
¾Press 
or 
until TCP/IP is displayed and press [Enter].
8.Network Setup [Reset Network]
8.Network Setup [Config Network]
Config Network
[TCP/IP]
Xerox WorkCentre PE120i System Administration Guide | Page |
