Basic TCP/IP Settings
Before the printer can be used on the network, the TCP/IP addresses need to be entered. These can be entered automatically using Dynamic Host Configuration Protocol (DHCP) or Bootstrap Protocol (BOOTP) or entered manually. To enter the addresses manually, you need to obtain the following:
¾TCP/IP Address
¾Gateway Address
¾Subnet Mask Address
¾Primary DNS Server Address
Installation Procedure
There are three stages required to install the WorkCentre PE120i in a TCP/IP networking environment:
¾Network Communication Setup
This requires the WorkCentre PE120i to be setup for TCP/IP.
¾Workstation Setup
This requires the Workstations in the networking environment to be configured to communicate with the WorkCentre PE120i.
¾Test Print
A print job should be submitted to ensure the WorkCentre PE120i has been installed and configured correctly.
Basic Network Installation
Xerox WorkCentre PE120i System Administration Guide | Page |
