
SSSU Command Reference
Step 1B script
Creates all source VDISKs used in DR groups on this controller.
Step 1C script
Presents all source VDISKs (creates LUNS) that are used for DR groups to their hosts. This step exists to assist in recovering from a DR failure in which a source site was lost. LUNs can be presented in their original configuration by running the correct step 1C script.
Step 2 script
Recreates all
This step provides flexibility when a site is completely lost. You must run step 1A, step 1B, and step 1C on both source and destination systems before step 2 can be run.
Note: If no destination VDSIK is presented to a host, a blank script will be generated for script 3.
Step 3 script
Presents remote VDISKs (creates LUNS) used for DR groups to their hosts.
You must run step 2 on both source and destination systems before step 3 can be run.
Restoring configurations
To restore system configuration from captured scripts, you must run the following scripts in the following order on each system that is part of the DR configuration.
Before running a captured configuration script, you need to modify an existing script, run an additional script, or enter commands directly at the command line setup, as in steps 1 and 2.
50 | Command View EVA Storage System Scripting Utility Reference Guide |