TROUBLESHOOTING
Problem | Cause | Remedy | Refer to | |
page | ||||
|
|
| ||
|
|
|
| |
Dolby Digital or DTS | The connected component is not set to | Make an appropriate setting following the operating | — | |
sources cannot be | output Dolby Digital or DTS digital | instructions for your component. |
| |
played. (The Dolby | signals. |
|
| |
Digital or DTS |
|
|
| |
The input mode is set to Analog. | Change the input mode setting to Auto or DTS. | 44 | ||
indicator on the front | ||||
panel display does |
|
|
| |
not light up.) |
|
|
| |
|
|
|
| |
A “humming” sound | The cable connections are incorrect. | Firmly connect the audio plugs. If the problem | — | |
can be heard. |
| persists, the cables may be defective. |
| |
|
|
|
| |
| The turntable is not connected to the GND | Connect the grounding cord of your turntable to this | 24 | |
| terminal. | unit’s GND terminal. |
| |
|
|
|
| |
The volume level is | The record is being played on a turntable | The turntable should be connected to this unit through | 24 | |
low while playing a | with an MC cartridge. | an |
| |
record. |
|
|
| |
|
|
|
| |
The volume level | The component connected to this unit’s | Turn on the power to the component. | — | |
cannot be increased, | OUT (REC) jacks is turned off. |
|
| |
or sound is distorted. |
|
|
| |
|
|
|
| |
The sound effect | It is not possible to record sound effects |
|
| |
cannot be recorded. | with a recording component. |
|
| |
|
|
|
| |
A source cannot be | The source component is not connected to | Connect the source component to the DIGITAL | ||
recorded by a digital | this unit’s DIGITAL INPUT jacks. | INPUT jacks. |
| |
recording component |
|
|
| |
Some components cannot record the |
|
| ||
connected to this |
|
| ||
unit’s DIGITAL | Dolby Digital or DTS sources. |
|
| |
OUTPUT jack. |
|
|
| |
|
|
|
| |
A source cannot be | The source component is not connected to | Connect the source component to the analog AUDIO | ||
recorded by an | this unit’s analog AUDIO input jacks. | input jacks. |
| |
analog component |
|
|
| |
connected to this |
|
|
| |
unit’s AUDIO OUT |
|
|
| |
jacks. |
|
|
| |
|
|
|
| |
The sound field | Memory Guard is set to Guard. | Select Free to enable changes to the sound field | 78 | |
parameters and some |
| parameters. |
| |
other settings on this |
|
|
| |
unit cannot be |
|
|
| |
changed. |
|
|
| |
|
|
|
| |
This unit does not | The internal microcomputer has been | Disconnect the AC power cord from the outlet and | — | |
operate properly. | frozen by an external electric shock (such | then plug it in again after about 30 seconds. |
| |
| as lightning or excessive static electricity) |
|
| |
| or by a power supply with low voltage. |
|
| |
|
|
|
| |
“CHECK SP WIRES” | The speaker cables have | Make sure all speaker cables are connected correctly. | 13 | |
appears on the front |
|
|
| |
panel display. |
|
|
| |
|
|
|
|
110