REMOTE CONTROL FEATURES

4Press MACRO again when the operation sequence you want to program is complete.

Memory back-up

If the remote control is without batteries for more than 3 minutes, or if exhausted batteries remain in the remote control, the contents of the memory may be cleared. If the memory is cleared, insert new batteries, set up the manufacturer code(s) and program any acquired functions that may have been cleared.

Clearing function sets

You can clear all changes made in each function set, such as learned functions, macros, renamed component (source) names and setup manufacturer codes.

1Press CLEAR by using a ballpoint pen or similar object.

CLEAR

y

Complete each of the following steps within 30 seconds. Otherwise, the learning mode is automatically canceled. In this case, press CLEAR again.

2Press k/n to select the clear mode.

L:DVD (L: name of a component)

Clears all learned functions for the respective component control area. Press an input selector button to select the component.

L:AMP Clears all learned functions for this unit’s control area.

L:ALL Clears all learned functions. M:ALL Clears all programmed macros.

RNAME Clears all renamed component (source) names. FCTRY Clears all remote functions and returns the remote

to the factory settings.

3Press and hold CLEAR again for about 3 seconds.

“C:OK” appears in the display window.

CLEAR

Note

“C:NG” appears in the display window if the operation was unsuccessful. In this case, start over from step 2.

4Press CLEAR to exit the clear mode.

Once you have cleared a learned function or macro for a button, the button reverts to the factory setting.

CLEAR

Note

“ERROR” appears in the display window under the following circumstances:

–When a button other than a cursor or ENTER is pressed.

–When more than one button is pressed simultaneously.

–When MACRO ON/OFF or 10KEY/AMP is switched to another position.

86