SYSTEM OPTIONS

Notes

•The available parameters may be displayed on more than one page of the on-screen display. To scroll through pages, press k/n.

•You cannot change parameter values when Memory Guard is set to “Guard”. If you want to change the parameter values, set Memory Guard to “Free” (see page 78).

Memory back-up

The memory back-up circuit prevents the stored data from being lost even if this unit is set in the standby mode, the power cord is disconnected from the AC outlet, or the power supply is temporarily cut due to power failure. However, if the power is cut for more than one week, the parameter values will return to the factory settings. If this happens, edit the parameter value again.

Input Select

Use this feature to reassign digital input/outputs, select the input signal, rename the inputs, or adjust the level of the signal input to each jack.

1Press TOP on the GUI remote control.

2Select Input Select, then press h.

3Select the desired input (CD, DVD, etc.), then press h to access and adjust.

■Mode (Mode)

Use this feature to select the input signal.

Input Select > input source (DVD, etc.) > Mode Choices: Auto, D.D.RF, DTS, Digital, i.LINK, Analog

y

•This menu is only available for input sources that have been assigned digital jacks.

•Before you can select i.LINK, you must first connect this unit to an i.LINK component and assign it to an input.

•Before you can select D.D.RF, you must first select DTV/LD as the input source and then specify 1 LD-RF for the Coaxial Input (see page 59).

58