6Press and hold the button you want to program on the remote control for your component until “OK” appears in the display window.

SOURCE

 

DTV/LD

CABLE

SYSTEM POWER

TRANSMIT

TITLE

DIRECT PURE

2 VCR 1 VCR

MD/TAPE SAT

AUX-V STANDBY

LEARN CLEAR NAME-RE

ENTER

 

DVR

R-CD

TUNER

MACRO

 

IN CH MULTI

DVD

CD

PHONO

MACRO ON OFF

Notes

• “NG” appears in the display window if programming was

unsuccessful. In this case, start over from step 5.

• This remote control can learn approximately 120 functions.

However depending on the signals learned, “FULL” may

REMOTE CONTROL FEATURES

Changing source names in the display window

You can change the name that appears in the display window on the remote control if you want to use a different name to the one that is factory preset. This is useful when you have set the input selector to control another component.

1Press an input selector button to select the source component you want to rename.

The selected component name appears in the display window.

V-AUX TUNER PHONO

CABLE SAT MD/TAPE CD-R CD

DTV/LD

VCR 1

VCR 2

DVR

DVD

2Press RE-NAME using a

appear in the display before you have programmed 120

functions. In this case, clear unnecessary programmed functions

to make room for further learning.

ballpoint pen or similar object.

RE-NAME

7Repeat steps 5 and 6 to program additional functions.

8Press LEARN again to exit from the learning mode.

LEARN

Notes

•Learning may not be possible in the following cases:

–When the batteries in the remote control for this unit or other components are weak.

–When the distance between the two remote controls is too great or too small.

–When the remote control infrared windows are not aimed at an appropriate angle.

–When the remote control is exposed to direct sunlight.

–When the function to be programmed is continuous or uncommon.

•“ERROR” appears in the display window if you press more than

one button at the same time.

3Press k/n to select and enter a character.

Pressing n changes the character as follows:

A to Z, a to z, 0 to 9, space, -(hyphen), and /(slash). (Pressing k changes the characters in reverse order.)

ENTER

4Press l / h to move the cursor to the next position.

ENTER

y

If you want to continue setting up names for other components, press ENTER and repeat steps 1, 3 and 4.

5Press RE-NAME again to exit from the renaming mode.

RE-NAME

OPERATION

ADVANCED

 

 

English

83