Yamaha DSP-Z9 Starting the setup

AUTO SETUP

Starting the setup

For best results, make sure the room is as quiet as possible during the auto setup procedure. If there is too much ambient noise, the results may not be satisfactory.

y

If your subwoofer can adjust the output volume and crossover frequency, set the volume to about half way (or slightly less), and set the crossover frequency to the maximum.

1Switch on the unit and video monitor, then press TOP on the GUI remote control.

The TOP display appears.

ENTER

TOPEXIT

GUI remote control

3Press k/n repeatedly to select Setup Menu, then press h.

4Press k/n repeatedly to select Wiring,

Distance, Size, Equalizing or Level.

2Press k/n repeatedly to select Auto Setup, then press h.

ENTER ENTER

For Wiring, Distance, Size or Level, select:

Check	To automatically check and adjust the selected
	item.
Skip	To skip the selected item and perform no
	adjustments.

y

When using THX speakers, select Skip and make sure that Small or Small x2 is selected in Speaker Set (page 67) and that 80Hz (THX) is selected in Cross Over (page 69).

32