REMOTE CONTROL FEATURES
5Press LEARN again to exit from the setup mode.
LEARN
Notes
•The supplied remote control does not contain all possible manufacturer codes for commercially available AV components (including YAMAHA AV components). If operation is not possible with any of the manufacturer codes, program the new remote control function with the Learn feature (see below) or use the remote control supplied with the component.
•If you have already programmed a remote control function for a button, the function by learning programming takes priority over the setup manufacturer code function.
•“ERROR” appears in the display window if you press a button not indicated in the respective step, or when you press more than one button at the same time.
Programming codes from other remote controls
If you want to program functions not included in the basic operations covered by the manufacturer code, or an appropriate manufacturer code is not available, do the following. You can program any of the buttons available in the component control area (see page 80). The buttons can be programmed independently for each component.
Note
This remote control transmits infrared rays. If the other remote control also uses infrared rays, this remote control can learn most of its functions. However, you may not be able to program some special signals or extremely long transmissions. (Refer to the operating instructions for the remote control of your component.)
1 Set 10KEY/AMP to 10KEY. | 10KEY AMP |
y
It is also possible to program in this unit’s control area with 10KEY/AMP set to AMP. However, if you do this, you will not be able to control this unit and select sound field programs.
2Press an input selector button to select a source component.
CABLE SAT MD/TAPE
DTV/LD | VCR 1 | VCR 2 | DVR | DVD |
3Place this remote control about 5 to 10 cm away from the remote control for your component on a flat surface so that their infrared transmitters are aimed at each other.
SOURCE |
|
| DTV/LD | CABLE | SYSTEM POWER | TRANSMIT |
TOP MODE INPUT | TITLE | DIRECT PURE | 2 VCR 1 VCR | MD/TAPE SAT | LEARN CLEAR | |
ENTER |
|
| DVR | TUNER | MACRO | |
EXIT |
| IN CH MULTI | DVD | CD | PHONO | MACRO ON OFF |
5 to 10 cm (2 to 4 in.)
4Press LEARN using a ballpoint pen or similar object.
Do not press and hold LEARN. If you hold down LEARN for more than 3 seconds, the remote control enters the manufacturer code setting mode.
LEARN
Flashes alternately
y
Complete each of the following steps within 30 seconds. Otherwise, the learning mode is automatically canceled. In this case, press LEARN again.
5Press the button for which you want to program the new function.
“LEARN” is displayed.
SOURCE |
| DTV/LD | CABLE | SYSTEM POWER | TRANSMIT |
TITLE | DIRECT PURE | 2 VCR 1 VCR | MD/TAPE SAT | LEARN CLEAR | |
ENTER |
| DVR | TUNER | MACRO | |
| IN CH MULTI | DVD | CD | PHONO | MACRO ON OFF |
82