Yamaha DSP-Z9 manual 87

■Macro operations

					MACRO
				MACRO	MACRO ON/OFF
TRANSMIT RE-NAME CLEAR LEARN MACRO				OFF ON
SYSTEM	STANDBY	V-AUX	TUNER	PHONO
POWER
CABLE	SAT	MD/TAPE	CD-R	CD	Macro buttons
DTV/LD	VCR 1	VCR 2	DVR	DVD

REMOTE CONTROL FEATURES

2Press the macro button you want to use to operate the macro.

The macro button name and the selected component name appear alternately in the display window.

V-AUX TUNER PHONO

PURE DIRECT

TITLE

MULTI CH IN

CABLE SAT MD/TAPE CD-R CD

DTV/LD VCR 1 VCR 2 DVR DVD

1Set MACRO ON/OFF to ON.

2Press a macro button.

Notes

•When you have finished using the macro feature, set MACRO ON/OFF to OFF.

•While the remote is carrying out a macro program, it will not accept any other button’s function until the macro operation is complete (the TRANSMIT indicator stops flashing).

•Continue to aim the remote control at the component the macro is operating until the macro operation is complete.

■Programming macro operations

You can program your own macros and use the macro feature to transmit several remote control commands in sequence at the press of a button. Be sure to set up manufacturer codes or perform learning operations before programming the macro. We do not recommend programming continuous operations such as volume control in a macro.

Notes

•The default macro is not cleared when a new macro is programmed for a button. The default macro can be used again when the programmed macro is cleared.

•It is not possible to add a new signal (macro step) to the default macro. Programming a macro changes all macro contents.

1Press MACRO using a ballpoint pen or similar object.

“MCR ?” appears in the display window.

MACRO

y

Complete each of the following steps within 30 seconds. Otherwise, the learning mode is automatically canceled. In this case, press MACRO again.

Flashes alternately

Notes

•“AGAIN” appears in the display window if you press a button other than a macro button.

•To change the selected source component, press SOURCE SELECT k/n. Pressing the input selector buttons will program a macro step, whereas SOURCE SELECT k/n only changes the selected component and corresponding component control area.

3Press the buttons for the functions you want to include in the macro operation in sequence.

You can set up to 10 steps (10 functions). After you have set 10 steps, “FULL” appears and the remote control automatically exits from the macro mode.

SYSTEM	STANDBY	V-AUX	TUNER	PHONO
POWER
CABLE	SAT	MD/TAPE	CD-R	CD
DTV/LD	VCR 1	VCR 2	DVR	DVD
		PURE DIRECT		MULTI CH IN
		TITLE
			ENTER
SOURCE	INPUT MODE	TOP		EXIT
	DISPLAY	MENU		SOUND
SELECT	SEARCH		– CHAPTER +
POWER	REC	STOP	PAUSE	PLAY	1	MCR 1: DVD a
				2		MCR 2: DVD h

Indicates the number of macro steps entered

Flashes alternately so you can set the next step

OPERATION ADVANCED

Note

“NG” appears in the display window if programming was unsuccessful. In this case, start over from step 2.

English

85