GETTING STARTED

Installing batteries in the remote controls

Notes on batteries

•Change all of the batteries if you notice the following conditions: the operation range of the remote control decreases, the indicator does not flash or its light becomes dim.

•Do not use old batteries together with new ones.

•Do not use different types of batteries (such as alkaline and manganese batteries) together. Read the packaging carefully as these different types of batteries may have the same shape and color.

•If the batteries have leaked, dispose of them immediately. Avoid touching the leaked material or letting it come into contact with clothing, etc. Clean the battery compartment thoroughly before installing new batteries.

■ Remote control

■ GUI remote control

RESET button

2

1

3

1Open the battery compartment cover.

2Insert three supplied batteries (AA, LR6) according to the polarity markings (+ and –) on the inside of the battery compartment.

3After new batteries are correctly inserted, press the RESET button in the battery compartment using a ball point pen or similar object.

(This does not clear the contents of the memory.)

4Replace the cover by pressing until it snaps into place.

If the remote control is without batteries for more than 3 minutes, or if exhausted batteries remain in the remote control, the contents of the memory may be cleared. If the memory is cleared, insert new batteries, set up the manufacturer code(s) and program any acquired functions that may have been cleared.

1Press the part and slide the battery compartment cover off.

2Insert two supplied batteries (AAA, R03) according to the polarity markings (+ and –) on the inside of the battery compartment.

3Slide the cover back until it snaps into place.

4