Yamaha 5TE-F8197-10, LIT-11616-16-02 Removing the Cylinder Head, Rotor holding tool YU-01235

CYLINDER HEAD

ENG

REMOVING THE CYLINDER HEAD

1.Align:

●“T” mark

(with stationary pointer)

*****************************************************

Checking steps:

●Turn the crankshaft counterclockwise with a wrench.

●Align the “T” mark 1 on the rotor with the stationary pointer 2 on the crankcase cover. When the “T” mark is aligned with the stationary pointer, the piston is at the Top Dead Center (T.D.C.).

NOTE:

●When the piston is at the Top Dead Center (T.D.C.) on the compression stroke, there should be clearance between the valve stem tips and their respective rocker arm adjusting screws.

●If there is no clearance, rotate the crankshaft counterclockwise one turn.

*****************************************************

2.Loosen:

●Camshaft sprocket bolt 1

NOTE:

Use the rotor holding tool 2 to hold the starter pulley.

Rotor holding tool:

P/N. YU-01235, 90890-01235

3.Loosen:

●Timing chain tensioner cap bolt 4.Remove:

●Timing chain tensioner

●Camshaft sprocket

4 - 10