Yamaha 5TE-F8197-10, LIT-11616-16-02 Toe-in = É È, Locknut rod end 40 Nm 4.0 m kg, 29 ft lb

ADJUSTING THE TOE-IN

CHK ADJ

●Measure the width È between the marks.

●Rotate the front tires 180° until the marks are exactly opposite one another.

●Measure the width É between the marks.

●Calculate the toe-in using the formula given below.

Toe-in = É – È

●If the toe-in is incorrect, adjust it.

*****************************************************

3.Adjust:

●Toe-in

WARNING

●Be sure that both tie-rods are turned the same amount. If not, the machine will drift right or left even though the handlebar is positioned straight. This may lead to mishandling and an accident.

●After setting the toe-in to specification, run the machine slowly for some distance with both hands lightly holding the handlebar and check that the handlebar responds correctly. If not, turn either the right or left tie-rod within the toe-in specification.

t

*****************************************************

Adjustment steps:

●Mark both tie-rods ends.

This reference point will be needed during adjustment.

●Loosen the locknuts (tie-rod end) 1 of both tie-rods.

●The same number of turns should be given to both the right and left tie-rods 2 until the specified toe-in is obtained. This is to keep the length of the rods the same.

●Tighten the rod end locknuts of both tie rods.

T .

R .

Locknut (rod end):

40 Nm (4.0 m • kg, 29 ft • lb)

NOTE:

Adjust the rod ends so that A and B are equal.

*****************************************************

3 - 48