104 Chapter 2. SONG MODE

• You use these two pages to select the output locations for
each track. The SEQ OUT CH. page sets up channel output
for the sequence tracks. The PATTERN OUT CH. page sets
up the output for the pattern tracks.
• You use the TO TG setting to set the track’s output channel
to the tone generator block.
• You use the MIDI OUT-A and MIDI OUT-B settings to
assign each track to a MIDI OUT channel.
• The QY700 stores separate channel arrangements for each
song. The assignments automatically change each time you
switch to a different song.
1. At the SONG PLAY screen, press 3 (OutCh).
▼The Output Channel setup screen appears.
2. Press u or d as necessary to se-
lect the track you want to work on.
• Note that the sequence-track settings and pattern-track set-
tings are shown on different pages. You can toggle between
the pages by pressing 6.
3. Move the cursor to the appropriate channel-setting
entry.
4. Change the value using the data dial, n/y, or the
numeric keypad.
5. When you have finished making changes, presse
to return to the SONG PLAY screen.
1. Track numbers, track name, and key-board track
• Each track is identified by a track number.
• The highlighted track number identifies the keyboard track.
The keyboard track is internally connected to the QY700
controller section.
0101
1101
Sequence track: 1,...,32
Pattern track: 1,...,16
Press u or d until the track number
for the desired track is highlighted.
• Use 6 as necessary to switch between the sequence-
track page and the pattern-track page.
• The keyboard track is indicated by highlight.
2. Measure and beat
• The measure value sets the start point for song playback.
• The measure and beat values increment during playback to
indicate the current song location
0101
1101
Measure: 001,...,999
1. Press d [D1] to move the cursor to the measure
setting area.
2. Set the measure value using the data dial, n/y, or
the numeric keypad.
• You can change the measure value while song playback is
in progress. Playback will immediately jump to the new
location.
• There are three ways to change the measure during play-
back, as follows.
• Press d [D1] to move the cursor to the measure
display area, and then change the value as described
above.
• Rotate the shuttle dial, or press r or f.
• Press t to return to the top of the song.
4. Output Channels