Yamaha QY700 5. Velocity 6. Pitch Bend 7. Control Change

137
2
Chapter 2. SONG MODE
5. Velocity
6. Pitch Bend
7. Control Change
• The VELCTY box lets you select whether or not to display
velocity values on the point graph. If you choose to display
these values, they are indicated by a symbol that appears
directly under the start point of each note. The scale runs
vertically from 1 (at the bottom) to 127 (at the top).
• The P.BEND box lets you select whether to display
pitchbend values on the point graph. If you choose to dis-
play these values, they are indicated by a symbol. The
scale runs from -8192 (bottom) to +8191 (top), with the
center of the graph (the dashed line) corresponding to 0.
• The point graph will only display one type of control-change
event. You use the CONTRL box to select the type, as well
as to enable or disable the display. You enable/disable the
display by setting or removing the checkmark. You select
the event type by entering the control-change number: for
example, 001 to show modulation-wheel events, or 011 to
display expression events. Occurrences of the selected con-
trol change event are indicated on the graph by the sym-
bol. The scale (for the control change argument) runs from
0 (bottom) to 127 (top).
0101
1101
To display on point graph:
To suppress from graph:
Control change number : #001,...,#031,#033,...,#119
1. Press d [D2], d [D3], or d [D4] to move
the cursor into the checkmark area of the VELCTY,
P.BEND, or CONTRL box.
2. Use n/y or the data dial to set or remove the
checkmark.
3. To change the control-change number: Press d
[D4] once or twice to move the cursor to the number-
setting area. Set the number using n/y or the data
dial.
6. Song Editing