16
SETUP
Rear panel
1. MIDI connectors
These connectors are used to connect external MIDI devices via a MIDI cable. There are four MIDI connectors: IN-A, IN-B, OUT-A, and
OUT-B. IN-A and IN-B are inputs, and OUT-A and OUT-B are outputs. ( p.20)
2. FOOT SW (Foot switch) jack
A foot switch (FC4, FC5: option) can be connected to this jack. A connected foot switch can be used during performance as a sustain pedal or
as a start/stop switch. ( p.290)
3. OUTPUT jacks
These jacks are for line connections to powered speakers or a mixer. When playing in stereo, connect both jacks. When playing in mono,
connect the L/MONO jack. ( p.19)
4. PHONES (Headphones) jack
A set of headphones with a stereo phone plug can be connected to this jack. (HPE-170 or other Yamaha recommended headphones: impedance
8 –150 ohms.) The headphone volume is adjusted by the Volume control. ( p.19)
5. DC IN (Power supply) jack
Connect the included PA-5B AC adaptor to this jack. ( p.18)
Before connecting the AC adaptor, make sure that the power switch of the QY700 is turned off. First connect the AC adaptor
to the power supply jack, and then plug it into an AC outlet.
Use only the included PA-5B AC adaptor. Using other AC adaptors will cause malfunctions. Also, be sure to unplug the AC
adaptor from the AC outlet if you will not be using the unit for an extended period of time.
6. Cable clip
Wrap the AC adaptor power cable around this clip as shown in the diagram. This will decrease the possibility of the power cable being pulled
out accidentally.
7. POWER switch
This switch turns the power on/off. The power is on when the switch is pressed in. ( p.18)
POWER
ON
INDCPHONESL/MONORSWFOOT
IN-AIN-BOUT-AOUT-B MIDI OUTPUT OFF
1. MIDI connectors
3. OUTPUT jacks
2. FOOT SW (Foot switch) jack
5. DC IN (Power supply) jack
7. POWER switch
4. PHONES (Headphones) jack
6. Cable clip
Cable clip