147
2
Chapter 2. SONG MODE
7. Song Jobs
JOB 03 MODIFY GATE TIME
3. Set all
Use this parameter if you want to set all targeted notes to
some identical gate time (1 to 9999). If you do not want to
use this feature (if you want to make the linear adjustment
instead), set the value to Off.
Note that if the setting is other than Off, the Rate and Offset
values are ignored.
0101
1101
Off (0), 0001,...,9999
4. Rate
The Rate parameter applies a proportional change to the
gate timing of all targeted notes. A setting of 100% pro-
duces no change; a setting of 50% cuts the gate time in half;
a setting of 200% causes the gate time to double.
0101
1101
000%,...,100%,...,200%
This job alters the gate times of the specified range of notes
(pitches) in the specified segment of the designated track.
The gate time refers to the length of time that a note is held.
For non-percussive voices, the gate time is equal to the ac-
tual playback time span.
Using this job, you can choose to change all targeted notes
to some fixed gate time, or you can apply a relative (linear)
adjustment to the original gate times.
If making a relative adjustment, you use two parameters:
the Rate and the Offset. The Rate value applies a propor-
tional change to the gate time, while the Offset value (which
is applied after the Rate adjustment) adds a fixed value. The
relation is as follows:
Adjusted gate time = (original gate time X Rate) + Offset.
If the adjustment result is less than 1, the QY700 sets the
value to 1.
1. Track setting: TR
This parameter selects the sequence track to which adjust-
ment is applied.
0101
1101
01,...,32
2. Segment and notes (M and Note=)
The two boxes at the top of the screen (to the right of the M)
select the track segment over which adjustment is carried
out. The first box sets the measure and beat for the start
point; the second box sets the end point. The Note boxes
select the range of notes (pitches) to be targeted by the ad-
justment: notes with pitches outside this range are not af-
fected.
0101
1101
Measure: beat 001:1,...,999:8
Note range C-2,...,G8
Original gate timing
Rate = 50%
Rate = 150%
(Gate)
(Gate)
(Gate)
32 32 32 48 48
16 16 16 24 24
48 48 48 72 72