242 Chapter 5. PATTERN MODE

• The Effect Connection Setup page selects the variation
mode, and the pan and transmission levels for each of the
three effects (variation, chorus, and reverb). You can also
use it to set the effect types themselves, although these set-
tings are also accessible from the corresponding edit pages
(→ p.244).
1. At the PATCH screen, press 3 (Effect).
▼The QY700 enters the Pattern Effects submode.
2. If necessary, press 1 (Connect) to move to the
Effect Connection Setup screen.
3. Move the cursor to the parameters that you need to
set, and change the values using the data dial, n/
y, or the numeric keypad.
4. When you are ready to return to the PATCH screen,
press e.
• The playback keys (p, s, t, r/f) continue to
function while you are adjusting the settings, so that you
can monitor the results of your changes as you make them.
1. Data display
• The data-display area shows the name and value of the cur-
rently selected parameter.
2. Variation mode
• This setting determines whether the variation effect is han-
dled as an insertion effect or as a system effect. (See the
illustrations on page 240.)
• If you set this value to Insertion, then you can apply the
variation effect to no more than a single part. In this case,
you can also use an assignable controller to control one of
the parameters for the effect in real time.
• If you set the value to System, then the variation effect op-
erates in the same way as the chorus and reverb effects —
so that you can apply it to all parts, and set values for the
send and return levels. But in this case you can not use a
controller to control the effect.
0101
1101
Insertion, System
• Insertion: Variation effect is handled as an insertion ef-
fect.
• System: Variation effect is handled as a system effect.
3. Reverb type
• This parameter selects the reverb effect type.
0101
1101
NO EFFECT, HALL 1, HALL 2, ROOM 1, ROOM 2, ROOM
3, STAGE 1, STAGE 2, PLATE, WHITE ROOM, TUNNEL,
BASEMENT
4. Reverb return
• This parameter sets the signal level returned from the reverb
block. You use this setting to adjust the reverb level for all
parts at the same time.
0101
1101
000,...,127
5. Reverb pan
• This parameter sets the stereo positioning of the signal from
the reverb block.
0101
1101
Left=63,...,Center,...,Right=63
6. Chorus Type
• This parameter selects the chorus effect type.
0101
1101
NO EFFECT, CHORUS 1, CHORUS 2, CHORUS 3, CHO-
RUS 4, CELESTE 1, CELESTE 2, CELESTE 3, CELESTE 4,
FLANGER 1, FLANGER 2, FLANGER 3
7. Chorus return
• This parameter sets the signal level returned from the cho-
rus block. You use this setting to adjust the chorus level for
all parts at the same time.
0101
1101
000,...,127
8. Chorus pan
• This parameter sets the stereo positioning of the signal from
the chorus block.
0101
1101
Left=63,...,Center,...,Right=63
4. Pattern Effects