Routine Maintenance
Clean Interior
Clean Interior
After every four rolls of media, inspect the inside of the printer. Use a soft bristle brush or a vacuum cleaner to remove any dirt and lint from the interior of the printer.
Printhead and Platen Roller
After every roll of ribbon, clean the printhead. Clean the printhead more often if you see inconsistent print quality, such as voids in the bar code or graphics.
Clean after every roll (1500 feet or 450 m) of thermal transfer ribbon or after every roll (500 feet or 150 m) of direct thermal labels or when CLEAN HEAD NOW appears on the LCD.
Note • You do not need to turn off the printer before cleaning the printhead. If power is turned off, all label formats and images, as well as any temporarily saved parameter settings stored in the printer’s internal memory, are lost. When power is turned back on, these items must be reloaded.
If print quality does not improve after you perform this procedure, clean the printhead with
Caution • The printhead is hot and can cause severe burns. Allow the printhead to cool.
Caution • Observe proper electrostatic safety precautions when handling any static- sensitive components such as circuit boards and printheads.
To clean the printhead and platen roller, complete these steps:
1.Open the printhead.
2.Remove the media and ribbon (if loaded).
3.Use Zebra’s Preventative Maintenance kit, part number 47362, or a solution of
90% isopropyl alcohol and 10% deionized water on an applicator to wipe along the print elements from end to end, as shown in Figure 40. (The print elements are on the brown strip on the printhead.) Allow a few seconds for the solvent to evaporate.
RXiIIIPlus User Guide | 91 |