Troubleshooting
LCD Error Messages
Table 11 • LCD Error Messages (Continued)
LCD | Possible Cause | Recommended Solution | ||
|
|
|
|
|
RIBBON IN | Ribbon is loaded, but the printer | • To operate in Direct Thermal mode, remove the | ||
| is set for Direct Thermal mode. |
| ribbon. | |
|
| • To operate in Thermal Transfer mode, leave the | ||
|
|
| ribbon loaded and change the print method to | |
|
|
| Thermal Transfer. See Selecting Print Method | |
|
|
| ||
|
| • Ensure that the printer driver and/or software | ||
|
|
| settings are correctly set (if applicable). | |
|
|
|
|
|
HEAD TOO HOT | The printhead is over | Printing automatically resumes when the printhead | ||
| temperature. | elements cool to an acceptable operating | ||
|
| temperature. | ||
|
|
|
| Caution • The printhead is hot and can |
|
|
|
| cause severe burns. Allow the printhead |
|
|
|
| to cool. |
|
|
|
| |
|
|
|
| Electrostatic Discharge Caution • |
|
|
|
| Observe proper electrostatic safety |
|
|
|
| precautions when handling any static- |
|
|
|
| sensitive components such as circuit |
|
|
|
| boards and printheads. |
CLEAN HEAD NOW The printhead requires cleaning. Clean the printhead according to the instructions in Printhead and Platen Roller on page 91.
Caution • The printhead is hot and can cause severe burns. Allow the printhead to cool.
Electrostatic Discharge Caution • Observe proper electrostatic safety precautions when handling any static- sensitive components such as circuit boards and printheads.
If the message does not go away after the printhead is cleaned, open the printhead and then close it.
102 | RXiIIIPlus User Guide | 6/21/2004 |