Front Panel Controls
Front Panel LCD
Table 5 • Printer Parameters (Sheet 3 of 15)
Parameter Action/Explanation
PRINT WIDTH Setting Print Width
Print width determines the printable area across the width of the label.
To change value shown:
1.Press the left oval to move the cursor.
2.Press the right oval to increase the value of the digit.
Note • The printer does not accept any value larger than the maximum print width listed in General Specifications on page 116.
To change the unit of measurement:
a.Press the left oval until the unit of measurement is active.
b.Press the right oval to toggle to a different unit of measure (mm, inches, or dots).
Default Range: The default and range of acceptable values vary depending on what printer you have. See General Specifications on page 116 for further information about the ranges available for your model.
MAXIMUM | Setting Maximum Length |
LENGTH | Maximum length is used in conjunction with the calibration procedure. The value of this |
| setting is the maximum label length that is used during the media portion of the calibration |
| process. Only a few labels are required to set media sensors. Always set the value that is at |
| least 1 in. (25.4 mm) longer than the longest label to be used on the printer. |
| • To increase the value, press the right oval. |
| • To decrease the value, press the left oval. |
| Default Range: The default and range of acceptable values vary depending on your |
| printer’s configuration. Values are adjustable in 1 in. (25.4 mm) increments. |
|
|
46 | RXiIIIPlus User Guide | 6/21/2004 |