RFID Guidelines

Sample of RFID Programming

Sample of RFID Programming

ZPL II is Zebra’s label design language. ZPL II lets you create a wide variety of labels from the simple to the very complex, including text, bar codes, and graphics.

This section is not intended as an introduction to ZPL II. If you are a new ZPL II user, order the ZPL II Programming Guide (part number 46530L) or go to http://support.zebra.com to download the guide.

For your programming, do the following:

1.Set up the printer and turn the power On (I).

2.Use any word processor or text editor capable of creating ASCII-only files (for example, use Microsoft® Word and save as a .txt file) and type in the label format exactly as shown in the sample label format shown in Table 7.

3.Save the file in a directory for future use. Use the “.zpl” extension.

4.Copy the file to the printer.

From the DOS command window, use the “COPY” command to send a file to the Zebra printer. For example, if your file name is format1.zpl then type,

COPY FORMAT 1.ZPL XXXX

where XXXX is the port to which your Zebra printer is connected (such as LPT1).

5.Compare your results with those shown. If your printout does not look like the one shown, confirm that the file you created is identical to the format shown, then repeat the printing procedure. If nothing prints, refer to

•Printer Setup on page 7

•Printer Operation on page 21

•Front Panel Controls on page 41

•Troubleshooting on page 99

to make sure that your system is set up correctly.

70

RXiIIIPlus User Guide

6/21/2004 23063L-001 Rev. 2