Routine Maintenance

Clean Interior

Snap Plate

Clean the snap plate when label adhesive or a label is stuck to the underside. Figure 44 shows the location of the snap plate.

Figure 44 • Snap Plate

12

6 5

4 3

1Antenna support screws

2Location of right-side snap plate screw (screw not shown)

3Snap plate

4Antenna support

5Antenna support frame

6Left-side snap plate screw

To clean the snap plate, complete these steps:

1.Remove the two screws that secure the snap plate to the antenna support frame.

Important • Do not remove the antenna support screws.

2.Remove the snap plate from the printer.

3.Clean the snap plate with cleaning solvent and a soft cloth.

4.To reinstall the snap plate, slide it back into place until the screw holes on the snap plate line up with the screw holes in the antenna support frame.

5.Reinstall the two snap plate screws to secure the snap plate to the antenna support frame.

23063L-001 Rev. 2 6/21/2004

RXiIIIPlus User Guide

95