Front Panel Controls

 

 

 

Front Panel LCD

 

 

 

Table 5 • Printer Parameters (Sheet 6 of 15)

 

 

 

 

 

Parameter

Action/Explanation

 

 

 

 

 

INIT FLASH

Initialize Flash Memory

 

MEM

Caution • Perform this operation only when it is necessary to erase all previously

 

 

stored information from Flash memory.

 

 

1. When the LCD displays INITIALIZE CARD , press the right oval to select YES .

 

(If you are prompted for a password, enter your password using the instructions in Password-Protected Parameters on page 43.)

The LCD asks INITIALIZE FLASH .

2. Press the right oval to select YES . The LCD asks ARE YOU SURE? .

 

3. Do you wish to continue?

 

• Press the left oval to select NO to cancel the request and return to the INIT FLASH

 

MEM prompt.

 

• Press the right oval to select YES and begin initialization.

 

When formatting is complete, INIT FLASH MEM displays.

 

 

SENSOR

Sensor Profile

PROFILE

The media sensor profile may be used to troubleshoot registration problems that may be

 

caused when the media sensor detects preprinted areas on the media or experiences

 

difficulty in determining web location.

 

• Press the right oval to start this standard calibration procedure and print a media sensor

 

profile.

 

Figure 29 shows a media sensor profile. If the sensitivity of the media and/or ribbon

 

sensors must be adjusted, use Calibrate Media and Ribbon Sensors on page 50 to adjust

 

the media and ribbon sensor sensitivity.

 

Figure 29 • Media Sensor Profile

 

 

23063L-001 Rev. 2 6/21/2004

RXiIIIPlus User Guide

49