Front Panel Controls
Front Panel LCD
ZebraNet® Wired Print Server LCD Displays
The menu options shown in Table 6 display only if you have the ZebraNet PrintServer II installed.
|
| Table 6 • Print Server LCD Displays |
|
| |
LCD | Explanation | |
|
|
|
IP |
| IP Resolution |
RESOLUTION | Depending on the selection, allows either the user (permanent) or the server (dynamic) to | |
|
| select the IP address. For more information, see the PrintServer II™ Installation and User |
|
| Guide. |
|
| • Press the right or left oval to display other choices. |
|
| Default: Dynamic |
|
| Selections: Dynamic, permanent |
|
|
|
IP | PROTOCOLS | IP Protocols |
|
| If Dynamic was chosen in the previous parameter, this selection determines the method(s) |
|
| by which the PrintServer II receives the IP address from the server. For more information, |
|
| see the PrintServer II™ Installation and User Guide. |
|
| • Press the right or left oval to display other choices. |
|
| Default: All |
|
| Selections: All, gleaning only, RARP, BOOTP, DHCP, DHCP/BOOTP |
|
|
|
IP | ADDRESS | IP Address |
|
| This parameter allows you to select the IP address if Permanent was chosen in IP |
|
| RESOLUTION. (If Dynamic was chosen, the user cannot select the address.) For more |
|
| information, see the PrintServer II™ Installation and User Guide. |
|
| 1. Press the left oval to move to the next digit position. |
|
| 2. Press the right oval to increase the value of the digit. |
|
| |
SUBNET MASK | Subnet Mask | |
This parameter selects the part of the IP address that is considered to be part of the local network. It can be reached without going through the default gateway.
• Press the right or left oval to display other choices. Default: Permanent (user must set)
Selections: Dynamic (user may set, but server can assign), permanent
DEFAULT GATEWAY
Default Gateway
This parameter allows you to select the IP address that the network traffic is routed through if the destination address is not part of the local network.
1.Press the left oval to move to the next digit position.
2.Press the right oval to increase the value of the digit.
RXiIIIPlus User Guide | 59 |