Zebra Technologies XiIIIPlus manual 147

I

idle display setting, 57 image not sharp, 104 images list, 48

initialize Flash memory, 49 inspect the printer, 9 interior cleaning, 91

international safety organization marks, 11 IP settings

default gateway, 59 IP address, 59

IP resolution, 59 protocols, 59 subnet mask, 59

L

label length maximum setting, 46 label specifications by model, 119 label top

printer cannot detect, 107 setting, 55

label-available sensor location, 93 when to clean, 90

labels did not print, 106 labels per roll setting, 47 language selection, 58 LCD messages

adjust LCD settings, 57 error messages, 101 language selection, 58 setup mode, 44

liability, vi

light or no printing, 104 lights on front panel, 5 list settings

all settings, 48 bar codes, 48 fonts, 47 formats, 48 images, 48 setup, 48

load the printer

load fanfold media, 24 load roll media, 22 ribbon, 26

long calibration, 33

lower media sensor adjustment, 37

Index

M

mark LED setting, 57 Mark Med S. setting, 57 maximum label length setting, 46 media

label specifications by model, 119 load fanfold media, 24

load roll media, 22 media LED setting, 57 media low warning, 47 non-continuous media, 15 RFID “smart” labels, 16 setting labels per roll, 47 setting media type, 45 types of media, 14

media and ribbon sensor calibration procedure, 34, 50

when to perform, 34 media path cleaning, 90 media power up setting, 54 Media S. setting, 57 media scratch test, 17 media sensor

adjustment, 36 location, 94

print media sensor profile, 49 sensor sensitivity calibration, 33

media types continuous media, 15

memory card installation CompactFlash card, 86 PCMCIA memory card, 84

modem connection, 79

N

network ID setting, 52 non-continuous media

setting media type, 45

O

operating conditions, 10

OUT OF MEMORY message, 103

23063L-001 Rev. 2 6/21/2004 RXiIIIPlus User Guide 123