2: Printer Installation

Installing the Printer

Connecting Power

Caution • Limit electrical power supplied to the printer to 24 VDC. Limit excess current draw to 16 amps or less, using an associated circuit breaker or other such device. Never operate the printer in a location where operator, computer, or printer can get wet.

Personal injury could result. The printer must be connected to an earthed electrical power supply and properly protected against electrical surges and grounding faults. The power supply pack can only be replaced by the same product from the manufacturer.

Caution • Do not power the printer with USB attached to your computer at this time.

THE DRIVER WILL PROMPT YOU WHEN IT IS TIME TO PLUG IN AND POWER UP YOUR PRINTER.

Step 1. Insert the power supply plug into the power socket, attach the power cord (120VAC or 230VAC) to the power supply, then plug the power cord in to a grounded electrical socket of the proper voltage and type.

120 VAC

230 VAC

Step 2. Ensure that the printer’s power switch is in the OFF (O) position.

P1060728-002

Zebra ZXP Series 1 Card Printer User’s Manual

11

Page 15
Image 15
Zebra Technologies zebra zxp series 1 user manual VAC 230 VAC, Connecting Power