Zebra Technologies zebra zxp series 1 user manual Loading Cards, Card Feeder

3:Printer Setup Loading Cards

Loading Cards

Card Feeder

The card feeder is used for loading cards, it can hold up to 100 cards of 30-mil thickness. The card feeder is located under the card feeder cover of the printer.Check with your card vendor or packaging label to identify the thickness of your cards. A typical card thickness is 30 mil.

1.Set the card thickness adjustment (circled below) to the number corresponding to the thickness of the cards being loaded. Note that the thickness adjustment ranges from 10 mils to 40 mils.

Failure to make the proper thickness adjustment (particularly for 10-mil cards) may result in a multiple-card jam. To clear a card jam, refer to MECHANICAL ERROR on page 75.

2.Open the card feeder cover.

34 Zebra ZXP Series 1 Card Printer User’s Manual P1060728-002