ZyXEL Communications ES3500 Series Port, Group, Apply, dst-ip, Cancel, Cancel, dst-mac, Criteria, src-dst-ip, destination IP addresses, destination MAC addresses, ES3500 Series User’s Guide

		Chapter 17 Link Aggregation
Table 47	Advanced Application > Link Aggregation > Link Aggregation Setting (continued)
LABEL		DESCRIPTION
Criteria		Select the outgoing traffic distribution type. Packets from the same source and/or to the same
		destination are sent over the same link within the trunk. By default, the Switch uses the src-
		dst-macdistribution type. If the Switch is behind a router, the packet’s destination or source
		MAC address will be changed. In this case, set the Switch to distribute traffic based on its IP
		address to make sure port trunking can work properly.
		Select src-macto distribute traffic based on the packet’s source MAC address.
		Select dst-macto distribute traffic based on the packet’s destination MAC address.
		Select src-dst-macto distribute traffic based on a combination of the packet’s source and
		destination MAC addresses.
		Select src-ipto distribute traffic based on the packet’s source IP address.
		Select dst-ipto distribute traffic based on the packet’s destination IP address.
		Select src-dst-ipto distribute traffic based on a combination of the packet’s source and
		destination IP addresses.
Port		This field displays the port number.
Group		Select the trunk group to which a port belongs.
		Note: When you enable the port security feature on the Switch and configure port security
		settings for a port, you cannot include the port in an active trunk group.
Apply		Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
		changes if it is turned off or loses power, so use the Save link on the top navigation panel to
		save your changes to the non-volatile memory when you are done configuring.
Cancel		Click Cancel to begin configuring this screen afresh.

	153
ES3500 Series User’s Guide