ZyXEL Communications ES3500 Series 17.5 Link Aggregation Control Protocol, ports, Active, Group ID, Click in the, System Priority, Link Aggregation, Control Protocol, Section 17.2 on page

Chapter 17 Link Aggregation

17.5 Link Aggregation Control Protocol

Click in the Advanced Application > Link Aggregation > Link Aggregation Setting > LACP to display the screen shown next. See Section 17.2 on page 149 for more information on dynamic link aggregation.

Figure 76 Advanced Application > Link Aggregation > Link Aggregation Setting > LACP

The following table describes the labels in this screen.

Table 48 Advanced Application > Link Aggregation > Link Aggregation Setting > LACP

LABEL	DESCRIPTION
Link Aggregation	Note: Do not configure this screen unless you want to enable dynamic link aggregation.
Control Protocol
Active	Select this checkbox to enable Link Aggregation Control Protocol (LACP).
System Priority	LACP system priority is a number between 1 and 65,535. The switch with the lowest
	system priority (and lowest port number if system priority is the same) becomes the LACP
	“server”. The LACP “server” controls the operation of LACP setup. Enter a number to set
	the priority of an active port using Link Aggregation Control Protocol (LACP). The smaller
	the number, the higher the priority level.
Group ID	The field identifies the link aggregation group, that is, one logical link containing multiple
	ports.

154
	ES3500 Series User’s Guide