Chapter 39 Access Control

Table 132 Management > Access Control > SNMP (continued)

LABEL

DESCRIPTION

Set Community

Enter the Set Community, which is the password for incoming Set- requests from the

 

management station.

 

The Set Community string is only used by SNMP managers using SNMP version 2c or

 

lower.

 

 

Trap Community

Enter the Trap Community string, which is the password sent with each trap to the

 

SNMP manager.

 

The Trap Community string is only used by SNMP managers using SNMP version 2c or

 

lower.

 

 

Trap DestinationUse this section to configure where to send SNMP traps from the Switch.

 

 

Version

Specify the version of the SNMP trap messages.

 

 

IP

Enter the IP addresses of up to four managers to send your SNMP traps to.

 

 

Port

Enter the port number upon which the manager listens for SNMP traps.

 

 

UsernameEnter the username to be sent to the SNMP manager along with the SNMP v3 trap.

 

Note: This username must match an existing account on the Switch (configured in the

 

Management > Access Control > SNMP > User screen).

 

 

Apply

Click Apply to save your changes to the Switch’s run-time memory. The Switch loses

 

these changes if it is turned off or loses power, so use the Save link on the top navigation

 

panel to save your changes to the non-volatile memory when you are done configuring.

 

 

Cancel

Click Cancel to begin configuring this screen afresh.

 

 

39.3.5 Configuring SNMP Trap Group

Click Management > Access Control > SNMP > Trap Group to view the screen as shown. Use the Trap Group screen to specify the types of SNMP traps that should be sent to each SNMP manager.

Note: Only the ES3500-24HP supports fanspeed and poe system traps.Figure 181 Management > Access Control > SNMP > Trap Group

302

 

ES3500 Series User’s Guide