ZyXEL Communications ES3500 Series Port, Apply, Source, Source, Cancel, Cancel, Example:, Advanced, Destination, Application, Basic Setting, the destination port(s)

Chapter 45 Configure Clone

The following table describes the labels in this screen.

Table 148 Management > Configure Clone

LABEL	DESCRIPTION
Source/	Enter the source port under the Source label. This port’s attributes are copied.
Destination	Enter the destination port or ports under the Destination label. These are the ports which
Port	are going to have the same attributes as the source port. You can enter individual ports
	separated by a comma or a range of ports by using a dash.
	Example:
	• 2, 4, 6 indicates that ports 2, 4 and 6 are the destination ports.
	• 2-6indicates that ports 2 through 6 are the destination ports.
Basic Setting	Select which port settings (you configured in the Basic Setting menus) should be copied to
	the destination port(s).
Advanced	Select which port settings (you configured in the Advanced Application menus) should be
Application	copied to the destination ports.
Apply	Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
	changes if it is turned off or loses power, so use the Save link on the top navigation panel to
	save your changes to the non-volatile memory when you are done configuring.
Cancel	Click Cancel to begin configuring this screen afresh.

334
	ES3500 Series User’s Guide