Briggs & Stratton 40248 manuel dutilisation Control Panel Controls and Features

Control Panel Controls and Features

Compare this illustration with your generator’s Control Panel, to familiarize yourself with the locations of the receptacles, controls and circuit breakers:

E

G

PUSH

TO 15A FUSE RESET

START/RUN/STOP

A

B

GFCI

MAIN BREAKER

E

PUSH

TO

RESET

C

F

120/240V 30A

120V 20A120V 20A

ALL RECEPTACLES GFCI-PROTECTED

E

D

A - LED Light — Generator is producing voltage when illuminated.

B - Ground Fault Circuit Interrupter/Breaker — Protects the generator from over-current conditions electrical faults to ground and must be in the “ON” position to supply power to all of the control panel receptacles.

C - START/RUN/STOP Switch — This three-position switch is used as follows:

•“START” position starts the generator. Press and hold to start generator.

•“RUN” position is switch position while generator is running.

•“STOP” position turns off the generator. Press and hold until engine stops.

D - 120/240V 30 Amp Locking Receptacle — Supplies the total generator output power and is GFCI protected.

E - Push-to-Reset Circuit Breakers — Protects the

generator from current overload at receptacle.

F - 120 Volt 20 Amp Receptacles — Each receptacle can supply a maximum of 20 amperes of power. The 120 Volt receptacles are GFCI protected. Total load on all four receptacles cannot exceed 7000 watts.

G - 15 Amp Fuse — Protects the generator DC control circuits. If the fuse has melted open or was removed, the engine cannot crank or start. Replace the fuse using only an identical ATO-type 15A fuse, available from most automotive parts stores.

12www.briggsandstratton.com