Teac AG-15D owner manual Speaker Setup Auto

1

2

3

4

AUTO SETUP

ALL CHANNEL

FL-C-FR-SR-SL

FL-FR-SR-SL

FL-C-FR

FL-FR

g:CUTOFF 80Hz :START t:SW 5b:MOVE OSD:BACK

100

Speaker Setup (Auto) 1

The test tone for the automatic speaker setup is very loud. Keep away from the speakers to protect your ears.

If a TV is connected to this unit, you can use the OSD (on-screen display) to set up the unit.

Make sure your TV is connected to the receiver and turned on.

1Connect a microphone to the MIC jack on the rear panel, and set it up on your listening position.

2Press the OSD button.

3Select “SPEAKER SETUP” and “AUTO” using the ENTER button.

4Check the options.

Number of available speakers

Press the 5 or b button (or the SPEAKER SETUP button of the main unit) to select the number of speakers connected to the unit.

ALL CHANNEL (SET ALL):

Front x2, Center x1, Surround x2,

Surround Back x1 or 2

FL-C-FR-SR-SL (SET 3/2):

Front x2, Center x1, Surround x2

FL-FR-SR-SL (SET 2/2):

Front x2, Surround x2

FL-C-FR (SET 3/0):

Front x2, Center x1

FL-FR (SET 2/0):

Front x2

Subwoofer

Press the t button (or the SELECT button of the main unit) to select Yes or No.

When a powered sub-woofer is connected, select Yes. (“S” appears on the right side of the display.)

Cut off frequency

Press the g button (or the SELECT button of the main unit) repeatedly.

You can change the setting from 40 to 130 Hz in 10 Hz steps. The default setting is 80 Hz.

Note

It is possible to use the automatic speaker setup function without the OSD, though it is rather difficult.

Instead of step 2 and 3 , hold down the SPEAKER

SETUP button for more than 1 second.

“SET ALL S” appears on the display.

<If you want to cancel the automatic speaker setup function, hold down the SPEAKER SETUP button for more than 1 second once again.

ENGLISH