Philips CDR 538 Finalizing CD-R & CD-RW discs, Unfinalizing CD-RW discs, Start analogue recording

Page 17

RECORDING

Start analogue recording

1To start recording, press PLAY on the CD recorder and immediately start the source.

➜RECORD lights continuously. The track number and recording time used appear on the display.

•To record a 3-second silence at the beginning of a track, press PAUSE.

•To check the (remaining) recording time, press Display. (This can also be done during the recording.)

2To stop recording, press STOP on the CD recorder. ➜ RECORD will go out.

•To interrupt recording, press PAUSE.

➜ RECORD will start to flash. Resume at step 1.

After recording the display will show UPDATE for several seconds.

Note: With AUTO TRACK on, the recorder will stop automatically after 20 seconds silence. With AUTO TRACK off, the AUTO STOP mode is disabled.

Finalizing CD-R & CD-RW discs

Finalizing is a simple procedure that is necessary in order to play the discs on a regular (non-recording) CD player.

Note: Finalizing prevents any further recording on a CD-R. A finalized CD-RW must be unfinalized to allow further recording or erasure of tracks.

1Make sure the disc is absolutely free of scratches and dust particles.

2With the recorder stopped press FINALIZE and then within 3 seconds press RECORD.

DIG AUTO TRACK REPEAT 1 TOTAL REM

TRACK TIME CD SYNC

ALOG

RECORD

FINALIZE

PROG

ERASE

L

COPY

RECORDABLE

➜The approximate finalization time will appear in the display. RECORD & FINALIZE lights up.

The display counts down through the finalization. On completion, the total number of tracks and the total time recorded will appear on the display.

For CD-R CD RECORDABLE will change to CD on the display. For CD-RW no change will be seen on the display.

Finalizing will last at least 2 minutes.

Note: During finalization, the CD recorder will not accept operating commands.

Unfinalizing CD-RW discs

For CD-RW discs only.

If you want to make more recordings (or to erase tracks) on a finalized disc you must unfinalize it first. The Table of Contents (TOC) on the disc will be removed.

To unfinalize:

1 Press ERASE twice.

➜On the display, TOC and ERASE will flash.

DIG AUTO TRACK REPEAT 1 TOTAL REM			TRACK TIME CD SYNC
LOG				RECORD

				FINALIZE
PROG				ERASE
		L		COPY
	RECORDABLE	L		COPY

2Press RECORD within 3 seconds.

➜ TOC and ERASE light up continuously during erasure.

English

Note: This will take approximately 1 minute.

15

Image 17

Contents CDR 560/538 CD recorder Important Safety Instructions Enspañol Français English ContentsSet complies with the FCC-Rules, Part 15 and with 21 CFR General InformationCD-R Player Limited WarrantyTechnical information English Table of contentsWelcome Accessories Discs for recording Maintenance EnglishDiscs for playback CD-Audio Recordable CD-R discsEnglish Operating Buttons and ConnectionsOperating buttons on the front Connections on the back Display messages DisplayDisplay explanation For use with FW538 InstallationConnections general Analogue connections Digital optical connections Digital coaxial connectionsPress ON/OFF to turn the CD recorder on Power supply Inserting batteries in the remote controlSet-up recommendations Remote control commands Remote Control & Inserting DiscsInserting discs Display will indicate the type of disc you have insertedRemarks about recording RecordingDigital recording unsynchronized Preparing for digital recordingStart digital recording Synchronized digital recording CD-SYNCPreparing for synchronized digital recording Start synchronized digital recordingStop the source Analogue recordingPreparing for analogue recording Unfinalizing CD-RW discs Finalizing CD-R & CD-RW discsStart analogue recording For CD-RW discs onlyEnglish Erasing CD-RW discs Erasing & PlayingPlaying a CD Selecting a track or searchingShuffle play PlayingRepeat CD, track or program ProgrammingDiagnostic program Fixing ProblemsEnglish Troubleshooting Table des matières GénéralitésBienvenue Caractéristiques techniquesDisques destinés à l’enregistrement Entretien Français AccessoiresDisques destinés à la lecture Les disques de type CD-R CD Audio RecordableConnexions à l’arrière Commandes ET ConnexionsCommandes en façade Prog DescriptionRepeat Utiliser avec la chaîne FW538 Connexions analogiquesGénéralités sur les connexions Tape Mise en place des piles dans la télécommande Conseils d’installationAlimentation Ouvrez le couvercle du compartiment des pilesDans le cas d’un CD-R finalisé, CD s’allume Mise en place des disquesFrançais Remarques préliminaires EnregistrementDémarrage de l’enregistrement numérique synchronisé Démarrage de l’enregistrement numériqueRecord clignote Arrêtez la source Enregistrement analogiquePréparation Démarrage de l’enregistrement analogique Finalisation disques CD-R et CD-RWAnnulation de la finalisation disques CD-RW Effacement des disques CD-RW Effacement ET LectureLecture d’un disque compact Pour effacer la dernière plageSélection d’une plage ou recherche Lecture en mode aléatoireLecture Effacement d’un programme ProgrammationAppuyez sur Play pour démarrer la lecture du programme Français Dépannage EN CAS DE ProblemesProgramme de diagnostic Remarques Indice Información GeneralBienvenido Datos técnicosDiscos para reproducción Discos para grabación Mantenimiento EnspañolAccesorios CD-audio grabables CD-RControles del panel frontal Conexiones del panel posterior Controles Y ConexionesDescripción de la pantalla PantallaMensajes de pantalla EnspañolPara ser utilizado con el mando FW538 InstalaciónConexiones generales Conexiones analógicas OUT Alog Digit Tical Pulse ON/OFF para encender el grabador de CD Recomendaciones de configuraciónAlimentación Inserción de las pilas en el mando a distancia Órdenes del mando a distancia Enspañol Mando a Distancia E Inserción DE DiscosInserción de discos Teclas numéricas 0 9 Seleccionan las pistas por su númeroAsegúrese de que el disco está absolutamente limpio y no GrabaciónInicie la grabación digital sincronizada Record record parpadeaPreparación para la grabación digital sincronizada En el grabador de CD Después de la grabación, la pantalla indicará UpdateDurante algunos segundos Realice grabaciones analógicas únicamente si no es posibleRehabilitación de discos CD-RW Finalización de discos CD-R y CD-RWInicie la grabación analógica Sólo discos CD-RWBorrado de discos CD-RW Borrado Y ReproducciónReproducción de un CD Para borrar la última pistaSelección de una pista o búsqueda ReproducciónReproducción aleatoria Selección de una pista con el disco paradoBorrado de un programa Repetición de CD, pista o programa ProgramaciónPulse Play para dar comienzo a la reproducción del programa Programa de diagnóstico Detección DE ProblemasEnspañol Solución de problemas 3104 125