4) Inputting the value for the remaining amount of plate (61m to 46m)
M3 F175 414 61m
M3 F175 414 41m
Press the 
key or the 
key to move the cursor to the remaining
amount display. Press the 
key or
the 
key to start the cursor flashing. Change the remaining
amount using the 
key or the
key and register the value with
the 
key.
*Press the MENU key to return to the original menu when you finish changing settings.
4.5Execution of Pre. Feed command (This procedure is necessary when loading the plate.)
Close the plate setting cover after the plate roll is set.
(1) Return the menu to the upper level 
menu using the MENU key.
(2)Select Pre. Feed (preliminary feeding mode) using the 
key.
Press the 
key to move to the lower level menu for the preliminary feeding mode.
(3)Use the 
key to set the plate feeding number to either "1" or "3"
(4)Start preliminary feeding with the 
key.
Note
- Press the | key after the preliminary feeding. Press the MENU key once to | |
call up the |
| display. Press the MENU key once more to call up the |
< Plate Data > | ||
display and switch to the
-Normally, a preliminary feeding must be performed to remove the fogged area after loading a new plate.
- 28 -