Mitsubishi Electronics SDP-ECO 1630 III manual Cleaning the processing chemical supply pipe

SDP-Eco1630 III USERS MANUAL

Filter	2)	Remove the filter installed in the
		processing chemical tank.
	3)	Wash the filter and processing
		chemical tank with water.
	4)	Re-install the filter in the
		processing chemical tank.

Note

Pull the cylindrical filter down over the filter attachment section in the processing chemical tank.

The filter must always be installed. If you attempt to operate this Caution machine without a filter, the processing chemical supply pipe will

become clogged and seriously affect subsequent results.

5)Return the processing chemical tank to its original position and replace its upper cover.

Since the heater is attached to the tank's upper cover, be sure the

Caution cover is properly seated into the top of the tank to prevent the heater from overheating.

•Cleaning the processing chemical supply pipe

Supply hose

Supply hose

Processing	Processing
		Processing
chemical supply	chemical supply	chemical supply
pipe (SLM-EST)	pipe (rinse water)	pipe (SLM-EAC)

Note Always clean the processing

chemical supply pipe when you replace the processing chemical every three months.

1)Remove the processing chemical supply pipes (for SLM-EAC, rinse water, and SLM-EST).

Supply hose	Processing chemical
	supply pipe

2)Remove the supply hose from the processing chemical supply pipe.

3)Clean the processing chemical supply pipe.

- 54 -