•Remaining amount of plate
The remaining amount of plate should be set in meter units when you use a new plate.
The initial setting value is 0 meter.
The remaining amount of plate is shown in 1 meter increments (0 to 75 meters) in the remote mode display
The remaining amount value is calculated by subtracting the exposed plate length from the plate length set by the operator. The plate length for preliminary feeding is also subtracted.
However, the accuracy of the remaining length measurement is not guaranteed. Please regard this value simply as a reference guide.
6.2 Laser menu
The laser menu contains a command to set the laser for exposing the current plate.
Sample panel display
Plate type | Resolution | Laser value |
F 1 7 5 | ( 1 2 ) | 2 0 0 |
|
|
|
•Resolution setting
(12)......1200dpi
(15)......1500dpi
(18)......1800dpi
(24)......2400dpi
•Laser setting
From the panel, you can set the exposure laser for each resolution to be used with the current plate.
1)Set the resolution and laser value.
2)If necessary, expose a trial sheet to adjust the laser.
- 42 -