JVC DLA-QX1G manual About status code

Controls and Features (cont.)

Control Panel (Cont.)

1	2	3	4	5	6	7 8
STAND BY			VIC SELECT		MENU	T	+
			1
OPERATE	HIDE
		KEY STONE 2				ZOOM	FOCUS
			3
				EXIT	ENTER	W	–
9 p q				w	e

qSTAND BY Indicator

On : When in stand-by mode.

Blinking : While in cool-down mode.

CAUTIONS

•The cool-down mode continues for about 10 minutes. At the first 20 seconds of the cool-down mode, the projection cannot be started again. During this period, the STAND BY indicator is blinking and “07” appear on the status code display.

Then, “07” changes into “06” on the status code display, but the STAND BY indicator is still blinking, and the cooling fans will continue to run for about 10 minutes before they stop.

After the cooling-down mode, the projector goes into stand-by mode automatically (the STAND BY indicator is not blinking but lit).

•The purpose of the cool-down mode is to prevent inner parts from being deformed or broken by heat from the heated lamp as well as to prolong the life of the lamp.

Do not turn off the MAIN POWER switch while in the cool-down mode. Also, do not block any of exhaust openings while in cool- down mode.

•The cooling fan for the light-source lamp power supply continues running as long as the MAIN POWER switch is turned on.

wEXIT button

Use this button in the menu mode to return to the previous menu. When the main menu is displayed, this button will cause the menu to disappear.

For details on the operations, refer to page 42.

eENTER button

Use this button in the menu mode. Use it to display the hierarchical menus. Also use it when “ENTER” is displayed for the item on the menu.

For details on the operations, refer to pages 16 and 42.

About status code

Normal indications

Code Status

00The projector is in stand-by mode.

01The projector is in normal status.

06The projector is in the cool-down mode. (enable to start the projection again)

07	The projector is in the cool-down mode.
Error indications
Code	Status
02	The side panel is unstable.
	Abnormal temperature in the lamp unit.
	The lamp cannot light up.
03	The internal shutter is closed or there may
	be trouble in the shutter function.
04	The projector is turned off while no signal is
	input.
10	The lamp goes off during projection.
20	Trouble in the light-source lamp power
	supply.
21	Trouble in the power supply of the projector.
22	Trouble in the power supply of the fan.
23	Trouble in cooling process of R-device.
24	Trouble in cooling process of G-device.
25	Trouble in cooling process of B-device.
30	Trouble in the fan or the sensor of air
	pressure.
40	Trouble in the micro processor.
80	The lamp life is near its end (exceed 900
	hours).
81	The lamp life is near its end (exceed 1000
	hours).
82	Abnormal temperature in the projector.
83	Abnormal temperature in the room.

ENGLISH

11