Basic Operations (Cont.)
■ Projector’s buttons | ■ Removing the trapezoidal distortion of the |
| image (KEYSTONE) |
KEYSTONE buttons
EXIT button
VIC SELECT
1
HIDE
KEY STONE 2
3
EXIT
If the image projected on the screen is distorted in trapezoid form, correct it with the KEYSTONE buttons. When the KEYSTONE button is pressed, the keystone indication appears on the screen.
Keystone 115
Keystone indication
Press the KEYSTONE 
/
buttons:
The trapezoid form is corrected as shown in the figure.
■Remote control unit
OPERATE
| HIDE |
| BACK |
| LIGHT |
LOCK |
|
UNLOCK | ENTER |
|
EXIT button
EXITMENU
VIC 1 VIC 2 VIC 3
T
ZOOM SHIFT FOCUS
W
KEYSTONE
buttons | ON | T |
DIGITAL
KEYSTONE SHUTTER ZOOM
OFF W
Remote control unit | Projector |
KEYSTONE
KEY STONE
Notes
•Before adjusting the trapezoidal distortion, adjust the shift setting. For details, refer to page 38.
•The trapezoidal distortion (keystone) can be adjusted within the range of 0 to 127.
•Adjustable range for correcting trapezoidal distortion (keystone) is 0˚ to +15˚.
When “Aspect” or “Panel” is selected as the Resize setting (see page 44), the adjustable range is limited as follows:
–While UXGA or SXGA signals are inputted, the range is 0˚ to +10˚.
–While analog HD signals are inputted, you cannot make any adjustment.
•The trapezoidal distortion (keystone) can be adjusted from the menu. For details, refer to page 46.
•Interference patterns may appear on the screen when adjusting the keystone. This is not a malfunction.
•Depending on the type of signal, some noise may appear in the picture when the keystone is adjusted. In this case, consult your dealer.
ENGLISH
(To be continued on the next page)
37