SAFETY PRECAUTIONS (Cont.)
POWER CONNECTION
(United Kingdom only)
WARNING
Do not cut off the main plug from this equipment.
If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appropriate safety approved extension lead or adapter or consult your dealer.
If nonetheless the mains plug is cut off, remove the fuse and dispose of the plug immediately, to avoid a possible shock hazard by inadvertent connection to the main supply.
If a new main plug has to be fitted, then follow the instruction given below:
WARNING:
THIS APPARATUS MUST BE EARTHED.
IMPORTANT:
The wires in the mains lead on this product are coloured in accordance with the following cord:
Green and Yellow | : Earth |
Blue | : Neutral |
Brown | : Live |
As these colours may not correspond with the coloured making identifying the terminals in your plug, proceed as follows:
The wire which is coloured 
with the letter E or the safety earth or coloured green or
The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black.
The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red.
When replacing the fuse, be sure to use only a correctly rated approved type,
IF IN DOUBT
Information on the power cord plug
The power cord of this projector does not have a wall outlet plug attached. We recomend you to select and attach a plug which matches your wall outlet.
Use a plug rated 250V/20A.
The wires ends of the power cord are covered for protection. Remove the covers before attaching the plug to the power cord.
–This equipment is in conformity with the provisions and protection requirements of the corresponding European Directives. This equipment is designed for professional projector appliances and can be used in the following environments.
•Controlled EMC environment (for example purpose built broadcasting or recording studio), and the rural outdoors environ- ment (far away from railways, transmitters, overhead power lines, etc).
In order to keep the best performance and furthermore for electromagnetic compatibility we recommend to use the cables not exceeding the following length:
AC INPUT | Power supply cord | 3 m |
REMOTE | Shielded cable | 15 m |
RGB ANALOG IN | Shielded cable | 3 m |
HDTV ANALOG IN | Shielded cable | 5 m |
RS232C CONTROL IN | Shielded cable | 3 m |
RS232C CONTROL OUT | Shielded cable | 3 m |
Shielded cable | 5 m |
• The inrush current of this apparatus is 17.250 amperes.
ENGLISH
5