JVC DLA-QX1G manual Remote Control Unit

Controls and Features (Cont.)

Remote Control Unit

						OPERATE
		N	y		MODE
		E
						BACK
LOCK						LIGHT
	UNLOCK	EX		LOCK
				UNLOCK	ENTER
t			r	EXIT		MENU
			e	VIC 1	VIC 2	VIC 3
			w	T
				ZOOM	SHIFT	FOCUS
				W
			q		ON	T
				KEYSTONE	SHUTTER	DIGITAL
						ZOOM
					OFF	W
STON	O
KEY				RM-MQX1G REMOTE CONTROL UNIT
		UNIT
		CONTROL
		REMOTE
		-MQX1G
	RM
		p

1

2

3

4

5

6

7

8

9

1Remote control’s signal transmitter

2OPERATE button

When the projector is in stand-by mode, press this button for one second or more to turn on the projector.

The OPERATE indicator lights up.

•About 30 seconds after the power has turned on, video image will appear on the screen.

When the projector is turned on, press this button for one second or more so that the projector goes into cool-down mode before going to stand-by mode.

For details, refer to “CAUTIONS” on page 11.

•The OPERATE button will not work for approximately 1 minute after the light-source lamp is turned on. Use the button approximately 1 minute later.

Memo

While in cool-down mode (the STAND BY indicator is blinking):

Even if you press the OPERATE button, the projector is not turned on. Wait until the projector enters stand-by mode. (The STAND BY indicator stays lit.)

3BACK LIGHT button

When this button is pressed, all the buttons light up. When no button is pressed while the buttons are lit, they will be turned off after several seconds.

4Cursor (5/∞/2/3) / ENTER button

When using this as the cursor button, press it in the 5/∞/2/3directions to select menu items or adjust settings. When using it as the ENTER button, press the button straight down.

The ENTER button is used in the menu mode. Use it to display the hierarchical menus. Also use it when “ENTER” is displayed for the item on the menu.

For details on the operation, refer to pages 16 and 42.

5MENU button

Use this button to enter or exit from the menu mode. The menu appears or disappears on the screen.

For details on the operation, refer to page 42.

6VIC 1, 2, and 3 buttons

You can select the desired VIC (Video Input Card) installed into the projector by pressing one of these buttons.

For details on the operations, refer to page 34.

7FOCUS +/– buttons

Use these buttons to adjust the focus of the projected video image.

+: The focus point becomes more distant.

–:The focus point becomes nearer.

For details on the operation, refer to page 35.

8DIGITAL ZOOM T/W buttons Not in use.

14