Baldor Baldor, MN850 manual Control

Using CE approved components will not guarantee a CE compliant system!

1.The components used in the drive, installation methods used, materials selected for interconnection of components are important.

2.The installation methods, interconnection materials, shielding, filtering and grounding of the system as a whole will determine CE compliance.

3.The responsibility of CE mark compliance rests entirely with the party who offers the end system for sale (such as an OEM or system integrator).

Baldor products which meet the EMC directive requirements are indicated with a “CE” mark. A duly signed CE declaration of conformity is available from Baldor.

AC Main

Supply

Four Wire “Wye”

PE

All shields

L1

L2

L3

Control		Note:
		Wiring shown for clarity of
L1 L2 L3 PE	T1 T2 T3	grounding method only.
		Not representative of actual
		terminal block location.
Route all power wires		Motor
L1, L2, L3 and Earth
		GND
(Ground) together in
conduit or cable.
Enclosure Backplane (see Section 2)

Note: Use shielded cable for control signal wires. Route control signal wires in conduit. These wires must be kept separate from power and motor wires.

A-2 Appendix MN850