Toshiba B-492L, R-TH10 owner manual A1.3.2 Detection Area of the Transmissive Sensor

APPENDIX 1 SPECIFICATIONS	EO1-33032
	A1.3 Media

A1.3.1		Media Type (Cont.)
					Unit: mm+(inch)
	?	Label dispensing mode	Batch mode		Strip mode
	Item
	@Width including backing paper		20 to 112 (0.8 to 4.4)
	ALabel width			Min. 17 (0.7)
	BLabel pitch		12 to 999 (0.5 to 39.3)		12 to 999 (0.5 to 39.3)
					10 ips: 25.4 to 999 mm (1 to 39.3)
	CLabel length		Min. 10 (0.4)		Min. 10 (0.4)
					10 ips: Min. 23.4 (0.9)
	DGap length (or black mark length)		2 to 20 (0.08 to 0.8)
	Black mark width			Min. 12 (0.5)
	Thickness		0.13 to 0.18 (0.005 to 0.007)
	Max. outer roll diameter		φ200 (Reference value, See NOTE 6.)
	Roll direction		Inside rolled paper is recommended.
	Inner core diameter		76.2±0.3 (3±0.01) (Reference value)

NOTES:

1.To ensure print quality and print head life use only TOSHIBA TEC approved media.

2.For the backing paper Glassine paper 7K white or equivalent should be used. Also, the light transmission rate of the backing paper should be 22% or above.

3.When perforating the media, it should be done from the print side to the reverse side.

4.Ink used for pre-printing the media should not contain hard substances such as carbonic calcium (CaCO3) and Kaolin (Al2O3, 2SiO2, 2H2O).

5.The reflectance of the black mark should be 10% or less when the wavelength is 950nm.

6.As this printer does not have a label holder, this figure is a guide for the system integrator using this printer. When the outer roll diameter of the labels being used is 200 mm or less, a hanging type supply holder similar to the type used in TEC desktop thermal printer’s will work correctly. When the outer roll diameter exceeds 200 mm, the label holder should have mechanisms, such as bearings, a damper, etc. to reduce the tension on the label. In any case, prior to actual operation, please be sure to test all practical conditions including the labels, system, etc. and confirm there is no problem.

A1.3.2 Detection Area of the Transmissive Sensor

The transmissive sensor is movable from the center to the left edge of the media.

The transmissive sensor detects gaps between labels, as illustrated below.

		Area to be detected.			Center of media
Sensor position					Print side
2 to 20 mm			Label
			Gap
			Label
	Min. 12 mm				Media feed direction
				Sensor is movable
				within this range.

A1- 3