Toshiba B-492L, R-TH10 owner manual Barcode, Non-Printing, Factory Test

APPENDIX 4 SYSTEM MODE	Characters&+$5$&7(56	EO1-33032
		A4.6 Test Print
A4.6 Test Print (Cont.)
Print Sample of Characters

While displaying the Characters, press the [PAUSE] key to start printing the characters%$5&2'(. After printing is completed, the display returns to “<4>TEST PRINT”.

Pressing the [PAUSE] key causes the display to show “CHARACTERS” again. Then, press the [FEED] key.

Barcode

Print Sample of Barcodes

While displaying the Barcode, press the [PAUSE] key to start printing the bar codes. After printing is completed, the display returns to “<4>TEST PRINT”.

Pressing the [PAUSE] key causes the display to show “BARCODE” again. Then, press the [FEED] key.

NOTE:

The Non-Printing function looks like a media feed.

Print Sample of Non-print

NOTES:

∙Factory test print conditions: One paper feed, Slant lines (3 dots), Bar codes, Characters, Item count: 5 pcs. each, Print speed: 5”/sec., Sensor type: Black or Feed gap sensor Ribbon type: Transparent

∙When the feed gap sensor is selected, a gap length is 3 mm.

Print method: Thermal

transfer, Issue mode: Batch

printing, Label length: 76 mm, Print tone fine adjustment.

Non-Printing

121￿35,17,1*

While displaying the Non-printing, press the [PAUSE] key to start issuing a blank page of media. After printing is completed, the display returns )to$“<4>TEST&725<7(67PRINT”.

Pressing the [PAUSE] key causes the display to show “NON- PRINTING” again. Then, press the [FEED] key.

Factory Test

While displaying the Factory test, press the [PAUSE] key to start printing the factory test pattern. After printing is completed, the display returns to “<4>TEST PRINT”.

Pressing the [PAUSE] key causes the display to indicate “FACTORY TEST” again. Then, press the [FEED] key.

A4-19