APPENDIX 4 SYSTEM MODE |
A4.5 Printer Parameter Fine Adjustment
A4.5 Printer Parameter Fine Adjustment (Cont.)
NOTE:
This is useful to fine adjust the threshold if problems with media issue persist after the sensor threshold setting is performed. (See Section 6.4 Threshold Setting) If the problem cannot be resolved, please contact your nearest TOSHIBA TEC service representative.
NOTE:
The fine adjustment value equals to the sum of the fine adjustment values set by the PC command and this parameter. The maximum strip motor driving speed fine adjustment value is +4 step. When the addition of the values reaches the maximum, the value remains unchanged even if subsequent fine adjustments are made.
Threshold Manual Fine Adjustment (Black Mark/Feed Gap Sensor)
(Black Mark Sensor) menu.
With this parameter you can fine adjust the Threshold of the Black Mark and Feed7+5(6+2/'Gap Sensors7!.With9 “<3>ADJUST SET” displayed, press the [PAUSE] key times to enter the Threshold Manual Fine Adjustment
7+5(6+2/'5!9
To change the screen to the Threshold Manual Fine Adjustment (Feed Gap Sensor), press the [PAUSE] key again.
Black Mark Sensor | Feed Gap Sensor |
[RESTART]
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| [FEED] | 7+5(6+2/' |
| 5!9 | 7+5(6+2/' |
| 7!9 | ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
[FEED] key: Pressing the [FEED] key once causes a
[RESTART] key: Pressing the [RESTART] key once causes a +0.1V change, up to +4.0V.
After completing the fine adjustment, press the [PAUSE] key.
Strip Motor3(/Driving2))63(('SpeedFine Adjustment
With this parameter you can fine adjust the speed of the backing paper peel motor (stepping motor). With “<3>ADJUST SET” displayed, press the [PAUSE] key 10 times to enter the Strip Motor Driving Speed Fine Adjustment menu.
[RESTART]
[FEED] | 3(/2))63((' |