Toshiba R-TH10, B-492L A4.5 Printer Parameter, Cont, Strip Position Fine Adjustment

APPENDIX 4 SYSTEM MODE	EO1-33032
	A4.5 Printer Parameter Fine Adjustment

A4.5 Printer Parameter			Strip Position Fine Adjustment
Fine Adjustment			With this parameter you can fine adjust the dispense position. With
(Cont.)
			“<3>ADJUST SET” displayed, press the		[PAUSE] key twice.
Strip Position Fine Adjustment			',6￿$'-￿￿￿￿￿PP		￿P
(Example)
	Label
+0.0 mm	Strip Plate	Print Head
Feed			[RESTART]
		Platen
Direction Backing					PP
+3.0 mm	Paper
-3.0 mm			[FEED]	',6￿$'-￿￿￿￿￿￿PP

NOTES:	[FEED] key:	Pressing the [FEED] key once causes a –0.5mm
1. In strip issue, the media feed
		change, down to –50.0 mm.
should be stopped where a 1	[RESTART] key:	Pressing the [RESTART] key once causes a
mm length of label remains		+0.5mm change, up to +50.0 mm.
on the strip plate. If,
however, the feed stop	After completing the fine adjustment, press the [PAUSE] key.
position is improper due to
too long gap length, etc., a
fine adjustment should be
performed.

2.The fine adjustment value equals the sum of the fine adjustment values set by the PC command and this parameter.

The maximum strip position fine adjustment value is ±50.0mm. When the addition of the values reaches the maximum, the value remains unchanged even if subsequent fine adjustments are made.

A4- 8