2. PRINTER SETUP |
2.2 Procedure before Operation
2.2Procedure before Operation
NOTE:
To communicate directly with a host computer, either an
(1)
(2)Centronics cable: 36 pins
(3)Expansion I/O cable: 24 pins (Option)
NOTE:
Use of a Windows Driver will allow issuing media on the B- 492L/R printer from a Windows application.
The printer can also be controlled with its own programming commands. Please contact your TOSHIBA TEC reseller for the Interface/Communication Manual.
This section describes the outline of the printer setup.
1.Unpack the accessories and printer from the box.
2.Refer to Safety Precautions in this manual and set up the printer at a proper location.
3.Attach the fan filter to the rear of the printer. (Refer to Section 2.3.)
4.The host computer must have an available serial port, Centronics parallel port or a Ethernet (option) connection. (Refer to Section 2.4.)
5.Connect the DC power cord plug to the printer. Connect the AC power cord to the Power Supply Unit. (Refer to Section 2.5.)
6.Load the media in the printer. (Refer to Section 2.7.)
7.Adjust the position of the Feed Gap Sensor or Black Mark Sensor to match the media being used. (Refer to Section 2.7.)
8.Load the ribbon onto the Ribbon Shafts. (Refer to Section 2.8.)
9.Turn the Power ON. (Refer to Section 2.6.)
10.Set the threshold. (Refer to Section 5.4.)
11.Perform a test print. (Refer to Section 2.10 and Appendix 4.6.)
12.Install the Printer Drivers. (Refer to Section 6.)
2.3Fitting the Fan Filter When installing the printer, it is important to ensure that the fan filter is attached before using the printer.
The fan filter consists of 2 parts:
(1)Filter Pad
(2)Filter Retainer
To fit the fan filter, put the filter pad inside the filter retainer and simply press into place as shown in the diagram below, ensuring connecting pins are aligned with the connecting holes.
Snap on
(2)
(1)
Snap on
2- 2