Toshiba R-TH10, B-492L owner manual A4.2 Overview, 2PARAMETER SET 5SENSOR ADJ RAM Clear 7IP Address

This will Reset the printer.

This leads to the Self-Diagnostic Test menu.

This leads to the Parameter Setting menu.

This leads to the Printer Parameter Fine Adjustment menu.

This leads to the Test Print menu.

This leads to the Sensor Adjustment menu.

This leads to the RAM Clear menu.

This leads to the IP Address Setting menu.

This leads to the DUMP mode menu.

APPENDIX 4 SYSTEM MODE EO1-33032

A4.2 Overview

A4.2 Overview

IMPORTANT!

The following menus are for Service Personnel only:

<2>PARAMETER SET <5>SENSOR ADJ. <6>RAM CLEAR <7>IP ADDRESS

Please do not change the settings for these items, as doing so may cause the printer to malfunction.

If you should accidentally enter these System Modes, to exit just turn the power off. If you should change any of the settings by accident and the printer malfunctions, please contact your nearest TOSHIBA TEC service representative.

NOTE:

1.To navigate the System Mode menus the [RESTART] and [FEED] key can be used.

2.Pressing the [PAUSE] key will enter the sub menus of each System Mode menu.

Flowcharts of each sub menu are provided on the following pages.

The System Mode consists of nine main menu items: Reset, Self- Diagnostic Test, Parameter Setting, Printer Parameter Fine Adjustment, Test Print, Sensor Adjustment, RAM Clear, IP Address Setting, and Dump mode.

the display￿￿￿￿!5(6(7!.',$*￿[RESTART]9[￿[

Press the [PAUSE] key so that the printer enters the Pause condition. Then, press and hold the [RESTART] key until “<0>RESET” appears on

[FEED]￿￿!3$5$0(7(5[RESTART]6(7

[FEED]

[RESTART]

[FEED]￿￿￿￿!7(67!$'-8673[RESTART]5,176(7 ￿￿!6(1625$'-￿

[FEED] [RESTART]

[FEED]￿￿!5$0&/([RESTART]$5

[FEED]￿￿￿￿!!'803,3$''5(6602'([RESTART]

[FEED] [RESTART]

[FEED] [RESTART]

[FEED]

A4- 2