Toshiba B-492L Setting the feed gap sensor position, Setting the black mark sensor position

2. PRINTER SETUP EO1-33032

2.7 Loading the Media

2.7Loading the Media (Cont.)

NOTES:

1.Turning the adjusting knob to the right will move the sensor towards the center of the media while turning it to the left will move it away from the center of the media.

2.Be sure to set the black mark sensor to detect the center of the black mark, otherwise a paper jam or no paper error may occur.

7.After loading the media, it may be necessary to set the media sensors used to detect the print start position of the labels. Set the black mark/feed gap sensor to the correct position by turning the adjusting knob.

Setting the feed gap sensor position

Turn the adjusting knob to move the feed gap sensor to the centre of the labels to detect the gap between labels. If the labels are round, set the sensor to detect the area of the shortest distance between the labels.

( indicates the position of the feed gap sensor).

Gap between Labels

Label

Label

Feed Gap Sensor

Adjusting Knob

Setting the black mark sensor position

(1)Pull about 500 mm of media out of the front of the printer, turn the media back on itself and feed it under the print head past the sensor so that the black mark can be seen from above.

(2)Turn the adjusting knob to move the black mark sensor so that it is

in line with the center of the black mark on the media. (	indicates
the position of the black mark sensor.)
Black Mark Sensor	Black Mark

Adjusting Knob

2- 8